ПЕДАЛЬ АКСЕЛЕРАТОРА ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ


  1. INSPECT ACCELERATOR PEDAL ASSEMBLY


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester main switch on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accelerator Position No. 1 and Accelerator Position No. 2.

    5. Read the value displayed on the intelligent tester.

      Standard Value
      Tester Display Condition Specified Condition
      Accel Sens. No.1 Volt % Released 10 to 22%
      Depressed 52 to 90%
      Accel Sens. No.2 Volt % Released 24 to 40%
      Depressed 68 to 99%

      If the result is not as specified, check the accelerator pedal, wire harness and ECM.