Click here

ECM СНЯТИЕ

Click here
Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    DISCONNECT CONNECTOR HOLDER BLOCK


    1. A015DXD

      Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.

  4. Click here

    REMOVE ECM


    1. A0155SHE02

      Raise the 2 levers while pushing the locks on the 2 levers.

      Table 1. Text in Illustration
      *a Lock
      *b Push
      Note:

      Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.

    2. Disconnect the 2 connectors.

    3. A0156EH

      Remove the 4 bolts and ECM.

  5. Click here

    REMOVE GASKET


    1. A01594V

      Peel off the gasket.

    2. A015CHOE02

      Spray gasket remover or equivalent on the remaining tape of the gasket.

      Note:

      When using gasket remover or equivalent, cover the ECM connectors with a cloth.

      Table 2. Text in Illustration
      *1 Cloth
    3. A01569O

      Remove the tape of the gasket without using bladed objects.