HAZARD WARNING SWITCH INSTALLATION

Tech Tips


  • Use the same procedures for the RHD and LHD.

  • The procedures listed below are the LHD side.


  1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    1. A0158QL

      Attach the 2 claws to install the hazard warning switch.

  2. INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (w/o Radio Receiver)

    A015D19

    1. Connect the connector.

    2. Attach the 10 claws to install the No. 1 center instrument cluster finish panel.

  3. INSTALL RADIO RECEIVER ASSEMBLY (w/ Radio Receiver)


    1. Connect the connectors.

    2. A0158M9

      Install the radio receiver with the 2 screws and 2 bolts.

      Torque:
      Bolt
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  4. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

    A0157V5

    1. Connect the connector.

    2. Attach the 6 claws to install the No. 4 instrument panel register.

  5. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    A0155N4

    1. Connect the connector.

    2. Attach the 6 claws to install the No. 3 instrument panel register.

  6. INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY

    A015A0J

    1. Attach the 8 claws to install the opening cover.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.