SIDE TURN SIGNAL LIGHT ASSEMBLY (for Outer Rear View Mirror) REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE OUTER REAR VIEW MIRROR LH

    Click here

  2. REMOVE OUTER MIRROR LH

    A0159WS

    1. Push the upper part of the mirror surface and tilt it.

    2. Using a moulding remover, detach the 4 claws and separate the outer mirror LH from the mirror body.

      Tech Tips

      Apply protective tape to the outer rear mirror LH to prevent it from being damaged.

    3. A0155J8

      w/ EC Mirror:

      Disconnect the connector and remove the outer mirror LH.

    4. A0156WG

      w/ Mirror Heater:

      Disconnect the 2 connectors and remove the outer mirror LH.

  3. REMOVE OUTER MIRROR COVER LH

    A015B2GE02

    Tech Tips

    Be sure to detach the claws of the outer mirror cover in the order shown in the illustration.


    1. A015CDOE01
      Text in Illustration
      *1 Protective Tape

      Using 2 screwdrivers, detach the 2 claws.

      Tech Tips

      Tape the screwdriver tip before use.

    2. Insert a screwdriver into the slot as shown in the illustration and push on the outer mirror body to create a space between the outer mirror body and outer mirror cover.

      Note

      Be careful not to break the ribs.

      Tech Tips

      Tape the screwdriver tip before use.

      A0158J0E01
      Text in Illustration
      *1 Protective Tape *2 Rib
      *a Inner Side of Outer Mirror Cover - -
    3. A015BJYE01
      Text in Illustration
      *1 Protective Tape

      Apply protective tape to the areas of the body cover and outer mirror cover as shown in the illustration.

      Tech Tips

      Tape the moulding remover before use.

    4. Insert a moulding remover into the space made between the outer mirror body and outer mirror cover.

      Note

      Do not insert the moulding remover more than 4 mm (0.157 in.).

      Standard
      Area Specified Condition
      a 4mm
    5. A015AZHE01
      Text in Illustration
      *1 Protective Tape

      Slide the moulding remover downwards as shown in the illustration to detach the 2 claws.

      Note


      • Do not insert the moulding remover more than 4 mm (0.157 in.).

      • Do not slide the moulding remover past the point approximately 40 mm (1.57 in.) from the bottom edge of the outer mirror cover as the outer mirror body will become damaged.

      Standard
      Area Specified Condition
      a 40mm
      b 4mm

    6. Remove the moulding remover B.

    7. A015B57E02
      Text in Illustration
      *1 Protective Tape
      *a Lower Side

      Apply protective tape to the areas of the body cover and outer mirror cover as shown in the illustration.

    8. Insert a moulding remover B between the outer mirror cover and outer mirror body as shown in the illustration and detach the claw.

    9. A0155M1E01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the claw.

    10. A0156EY

      Detach the 2 claws and remove the outer mirror cover.

      Note

      When removing the cover, be careful not to damage the side turn signal light assembly or cover.

  4. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH


    1. A015ATN

      Remove the 3 screws and light.

    2. Disconnect the connector.