LIGHTING SYSTEM Headlight Dimmer Switch Circuit

DESCRIPTION

The turn signal flasher receives a turn signal light information signal from the headlight dimmer switch.

WIRING DIAGRAM

A015BXRE01

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT HEADLIGHT DIMMER SWITCH (TURN SIGNAL SWITCH)


    1. A015CPQE02

      Remove the headlight dimmer switch Click here.

    2. for LH Side:

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      13 (TR) - 12 (EL) Turn signal switch right turn Below 1 Ω
      Turn signal switch off 10 kΩ or higher
      15 (TL) - 12 (EL) Turn signal switch left turn Below 1 Ω
      Turn signal switch off 10 kΩ or higher
    3. A015DMNE01

      for RH Side:

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      16 (TR) - 19 (EL) Turn signal switch right turn Below 1 Ω
      Turn signal switch off 10 kΩ or higher
      18 (TL) - 19 (EL) Turn signal switch left turn Below 1 Ω
      Turn signal switch off 10 kΩ or higher

    NG

    REPLACE HEADLIGHT DIMMER SWITCH Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH - TURN SIGNAL FLASHER AND BODY GROUND)


    1. A0159J2E02

      Disconnect the E14 switch connector.

    2. Disconnect the E19 relay connector.

    3. for LH Side:

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E14-13 (TR) - E19-6 (ER) Always Below 1 Ω
      E14-15 (TL) - E19-5 (EL)
      E14-12 (EL) - Body ground
      E14-13 (TR) - Body ground Always 10 kΩ or higher
      E14-15 (TL) - Body ground
    4. A0159J2E01

      for RH Side:

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E14-16 (TR) - E19-6 (ER) Always Below 1 Ω
      E14-18 (TL) - E19-5 (EL)
      E14-19 (EL) - Body ground
      E14-16 (TR) - Body ground Always 10 kΩ or higher
      E14-18 (TL) - Body ground
      Result
      Result Proceed to
      OK (for LHD) A
      OK (for RHD) B
      NG C

    B

    REPLACE TURN SIGNAL FLASHER ASSEMBLY Click here

    C

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    A

    REPLACE TURN SIGNAL FLASHER ASSEMBLY Click here