DESCRIPTION
The headlight leveling ECU*1 or headlight swivel ECU*2 stores this DTC if the sensor value received from the rear height control sensor LH is out of range when performing initialization of the headlight leveling ECU*1 or headlight swivel ECU*2; for example, the vehicle is not level or is being jacked up.
*1: w/ Static Headlight Auto Leveling
*2: w/ Dynamic Headlight Auto Leveling
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2452 | The sensor value received from the rear height control sensor LH is out of range when performing initialization. |
|
INSPECTION PROCEDURE
Note
After replacing the headlight leveling ECU*1 or headlight swivel ECU*2, initialization of the ECU is necessary Click here.
*1: w/ Static Headlight Auto Leveling
*2: w/ Dynamic Headlight Auto Leveling
PROCEDURE
PERFORM INITIALIZATION
Perform initialization of the headlight leveling ECU*1 or headlight swivel ECU*2 Click here.
*1: w/ Static Headlight Auto Leveling
*2: w/ Dynamic Headlight Auto Leveling
Tech Tips
Before initializing, make sure that the vehicle condition is proper for initialization.
Be sure to perform the initialization as instructed.
| NEXT |
|
CHECK FOR DTC
Check for DTCs Click here.
| OK |
|---|
| DTC B2452 output does not occur. |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/ Static Headlight Auto Leveling) | B |
| NG (w/ Dynamic Headlight Auto Leveling) (for LHD) | C |
| NG (w/ Dynamic Headlight Auto Leveling) (for RHD) | D |
Tech Tips
If the headlight leveling ECU*1 or headlight swivel ECU*2 stores DTC B2452 even though the ECU has been initialized as instructed, there may be a malfunction in the headlight leveling ECU*1 or headlight swivel ECU*2.
*1: w/ Static Headlight Auto Leveling
*2: w/ Dynamic Headlight Auto Leveling
| B |
|
REPLACE HEADLIGHT LEVELING ECU ASSEMBLY Click here |
| C |
|
REPLACE HEADLIGHT SWIVEL ECU ASSEMBLY Click here |
| D |
|
REPLACE HEADLIGHT SWIVEL ECU ASSEMBLY Click here |
| A |
|
END