LIGHTING SYSTEM OPERATION CHECK


  1. CHECK ILLUMINATED ENTRY SYSTEM OPERATION


    1. The illuminated entry system controls the following lights:


      • Engine switch illumination*1

      • Map light*2

      • Room light


      • *1: except Double Swing Out Type

      • *2: w/ Map Light

    2. Check the illuminated entry system with the ignition switch off.


      1. Check that the lights turn on when unlocking any of the doors that are closed and locked with the ignition switch off. Then check that the lights fade out under the following conditions:


        • Leave the doors unlocked for 15 seconds.

        • Turn the ignition switch to ACC or ON.

        • Lock all the doors.

      2. Check that the lights stay on for at least 15 seconds after opening any of the doors before fading out. Then check that the lights fade out 15 seconds after closing all the doors.

    3. Check the illuminated entry system with the ignition switch to ACC or ON.


      1. Check that the lights stay lit after turning the ignition switch off with all the doors closed and the ignition switch to ACC or ON. Then check that the lights fade out under the following conditions:


        • Leave the doors unlocked for 15 seconds.

        • Turn the ignition switch to ACC or ON.

        • Lock all the doors.

      2. Check that the lights stay on for at least 15 seconds after opening any of the doors. Then check that the lights fade out 15 seconds after closing all the doors.

      3. Check that the lights turn on when opening any of the doors and fade out when closing and locking all the doors or turning the ignition switch to ACC or ON.

  2. CHECK BATTERY SAVER OPERATION


    1. Basic function inspection


      1. Check that the applicable lights are turned off approximately 20 minutes after the ignition switch is turned off with any door left open or ajar.

    2. Interior light auto cut function inspection (w/ Dome Cut Relay)


      1. Check that the applicable lights are turned off approximately 20 minutes after the ignition switch is turned off regardless of the open/close status of the doors or the position of the map light switch.

  3. CHECK LIGHT AUTO TURN OFF OPERATION


    1. Prepare the vehicle so that the ignition switch is ON and the driver door is closed.

    2. Set the headlight dimmer switch assembly to TAIL, HEAD or AUTO to illuminate the lights.

    3. Turn the ignition switch off and open the driver door. When the headlight dimmer switch is on AUTO, check that the headlights, fog lights, and taillights turn off. When the headlight dimmer switch is on head or tail, check that the headlights and front fog lights turn off.

  4. AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM OPERATION CHECK (w/ Static Headlight Auto Leveling)


    1. Check that the initialization (determination of the initial position) of the headlight leveling motor is performed when the ignition switch is turned to ON.

    2. Check that the headlight beam level control system warning light in the combination meter assembly comes on for approximately 3 seconds when the ignition switch is turned to ON, and then turns off.

    3. Check that the headlight moves when all of the following conditions are met: 1) the rear of the vehicle is moved up or down, 2) the engine is running, 3) the vehicle is stopped, and 4) the light control switch is in the head position.

      Note

      Make sure to change the vehicle height slowly.

  5. AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM OPERATION CHECK (w/ Dynamic Headlight Auto Leveling)


    1. Check that the initialization (determination of the initial position) of the headlight leveling motor is performed after the engine is started.

    2. Check that the headlight beam level control system warning light in the combination meter comes on for approximately 3 seconds and then goes off when the ignition switch is turned to ON.