Click here

WASHER NOZZLE (for Front Side) INSTALLATION

Click here
Click here Click here
Tip:

  • Use the same procedure for the LH and RH sides.

  • The procedure listed below is for the LH side.

Click here
  1. Click here

    INSTALL WASHER NOZZLE SUB-ASSEMBLY (w/ PTC Heater)


    1. Connect the hose.

    2. A015AWG

      Attach the 4 claws to install the washer nozzle.

    3. A015CR6

      Connect the connector and attach the connector clamp.

  2. Click here

    INSTALL WASHER NOZZLE SUB-ASSEMBLY (w/o PTC Heater)


    1. A0157UG

      Attach the 3 clamps to install the washer nozzle.

    2. Connect the hose.

  3. Click here

    INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    1. A0157PPE01

      Push the ventilator louver in the direction indicated by the arrow in the illustration to attach the 17 claws and 2 clips and install the ventilator louver.

  4. Click here

    INSTALL HOOD TO COWL TOP SEAL


    1. A0155QV

      Attach the 12 clips and 4 clamps to install the hood to cowl top seal.

    2. A015DL2

      Install the washer hose.

  5. Click here

    INSTALL FRONT FENDER MAIN SEAL LH


    1. A0155CK

      Attach the 3 clips to install the fender main seal.

  6. Click here

    INSTALL FRONT FENDER MAIN SEAL RH

    Tip:

    Use the same procedure described for the LH side.

  7. Click here

    INSTALL UPPER RADIATOR SUPPORT SEAL


    1. A015BVKE02

      Install the radiator support seal with the 7 clips.

  8. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  9. Click here

    INSTALL FRONT WIPER ARM LH


    1. A015AKQE01

      Stop the wiper motor at the automatic stop position.

    2. Clean the wiper pivot serration with a wire brush.

    3. A0155U4E01

      Install the wiper arm and blade with the nut. Make sure that the wiper arm and blade comes to the position shown in the illustration.

      Standard Measurement
      Position Specified Condition
      A 16.8 to 36.8 mm (0.661 to 1.45 in.)
      25 N*m 255 kgf*cm 18 ft.*lbf
      Tip:

      Hold down the wiper arm hinge with your hand while tightening the nut.

  10. Click here

    INSTALL FRONT WIPER ARM RH


    1. A015AKQE01

      Stop the wiper motor at the automatic stop position.

    2. Clean the wiper pivot serration with a wire brush.

    3. A015AOHE01

      Install the wiper arm and blade with the nut. Make sure that the wiper arm and blade comes to the position shown in the illustration.

      Standard Measurement
      Position Specified Condition
      B 20.0 to 40.0 mm (0.787 to 1.57 in.)
      25 N*m 255 kgf*cm 18 ft.*lbf
      Tip:

      Hold down the wiper arm hinge with your hand while tightening the nut.

    4. Operate the front wipers while spraying washer fluid on the windshield glass. Make sure that the front wipers function properly and there is no interference with the vehicle body.