REAR WIPER MOTOR (for Double Swing Out Type) INSTALLATION

INSTALL REAR WIPER MOTOR GROMMET

1. 

   Text in Illustration

   *1

   MP Grease

   Apply MP grease to the entire inner surface of the rear wiper motor grommet.

   Tech Tips

   Make sure that the hole does not get clogged with grease and the grooves in the grommet are filled with grease.

2. 

   Text in Illustration

   *1	Position Mark
   *a	Upward

   Install the rear wiper motor grommet.

   Tech Tips

   Install the grommet with its position mark facing up.

INSTALL REAR WIPER MOTOR ASSEMBLY

1. Temporarily install the rear wiper motor assembly with the 3 bolts.

2. Tighten the 3 bolts.

   Torque:

   5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

3. Connect the connector.

INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

1. 

   Text in Illustration

   *1	Wiper Arm Serrations
   *2	Wire Brush
   *3	Wiper Pivot Serrations

   Clean the wiper arm serrations.

2. Clean the wiper pivot serrations with a wire brush.

3. Operate the rear wiper, and stop the rear wiper motor at the automatic stop position.

4. 

   Text in Illustration

   *1	Mark for Blade Position

   Align the tips of the blade with the marks as shown in the illustration.

5. Install the rear wiper arm and blade assembly with the nut.

   Torque:

   5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

6. Close the wiper arm head cap.