POWER BACK DOOR CLOSER SWITCH INSPECTION


  1. INSPECT BACK DOOR CONTROL SWITCH


    1. A015B9FE02
      Text in Illustration
      *a

      Component without harness connected

      (Back Door Control Switch)
      *b Not pushed (off)
      *c Pushed (on)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      3 - 4 Pushed (on) Below 1 Ω
      3 - 4 Not pushed (off) 10 kΩ or higher

      If the result is not as specified, replace the back door control switch.

    2. Apply battery voltage to the connector and check the LED illumination.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → terminal 2(ILL+)

      Battery negative (-) → terminal 1(ILL-)

      		 Illuminates