POWER BACK DOOR SYSTEM ECU Power Source Circuit

DESCRIPTION

This circuit supplies power to operate the power back door unit assembly (power back door ECU).

WIRING DIAGRAM

A0155KUE02

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (POWER BACK DOOR UNIT ASSEMBLY [POWER BACK DOOR ECU] - BATTERY AND BODY GROUND)

    A01577HE57
    Text in Illustration
    *a

    Front view of wire harness connector

    (to Power Back Door Unit Assembly [Power Back Door ECU])

    1. Disconnect the power back door unit assembly (power back door ECU) connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      L52-10 (ECUB) - Body ground Always 11 to 14 V
      L52-12 (B) - Body ground Always 11 to 14 V
      L52-8 (IG) - Body ground Engine switch on (IG) 11 to 14 V
      L52-8 (IG) - Body ground Engine switch off Below 1 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L52-11 (GND) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here