POWER BACK DOOR CONTROL SWITCH INSPECTION


  1. INSPECT DOOR CONTROL SWITCH


    1. A015A1HE01
      Text in Illustration
      *a

      Component without harness connected

      (Door Control Switch)
      *b Not pushed (off)
      *c Pushed (on)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      3 (E) - 6 (CSW) Pushed (on) Below 1 Ω
      3 (E) - 6 (CSW) Not pushed (off) 10 kΩ or higher

      If the result is not as specified, replace the door control switch.

    2. Apply battery voltage to the connector and check the LED illumination.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → terminal 5 (ILL+)

      Battery negative (-) → terminal 4 (ILL-)

      		 Illuminates