SLIDING ROOF HOUSING DISASSEMBLY


  1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A015DB2

      Detach the bracket claw and remove the bracket.

    2. A015BPK

      Remove the 2 bolts, room light bracket and drive gear.

  2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY

    A015DK6E01

    1. Remove the 2 screws.

    2. Detach the 4 claws and remove the sliding roof piece LH and RH.

    3. Slide and remove the trim.

  3. REMOVE SLIDING ROOF SUNSHADE STOPPER LH


    1. A015DBX

      Remove the stopper.

  4. REMOVE SLIDING ROOF SUNSHADE STOPPER RH

    Tech Tips

    Use the same procedures described for the LH side.

  5. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

    Note

    Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.


    1. A015A5O

      Remove the 2 screws and 2 stoppers.

    2. A0155QEE01

      Using a screwdriver, detach the 2 claws slide the rear roof drip channel rearward to remove it.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A0155ZI

      Hold down the window deflector.

    4. A0157RSE01

      Place matchmarks on the sliding roof drive cable sub-assembly at locations A and B as shown in the illustration.

    5. A0157ZLE01

      Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

      Tech Tips

      Tape the screwdriver tip before use.