Click here

SLIDING ROOF SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Click here
Click here Click here
Tip:

  • Use these procedures to troubleshoot the sliding roof system.

  • *: Use the intelligent tester.


  1. Click here

    VEHICLE BROUGHT TO WORKSHOP


    • NEXT
  2. Click here

    INSPECT BATTERY VOLTAGE

    Standard Voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.


    • NEXT
  3. Click here

    CHECK LIN COMMUNICATION SYSTEM*


    1. Using the intelligent tester, check if the LIN communication system is functioning normally.

      Table 1. Result
      Result Proceed to
      LIN communication system DTC is not output A
      LIN communication system DTC is output B

      • B
      • Go to LIN COMMUNICATION SYSTEM (See pageClick here)
      • A
  4. Click here

    PROBLEM SYMPTOMS TABLE


    1. Refer to the problem symptoms table (Click here).

      Table 2. Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

      • B
      • Go to step 6
      • A
  5. Click here

    OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Operation Check (Click here).

    2. Terminals of ECU (Click here).

    3. Data List / Active Test (Click here).


      • NEXT
  6. Click here

    ADJUST, REPAIR OR REPLACE


    • NEXT
  7. Click here

    INITIALIZATION


    1. Initialization (Click here).


      • NEXT
  8. Click here

    CONFIRMATION TEST


    • NEXT
    • END