POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows) Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch

DESCRIPTION

• If the auto up/down function does not operate, the cause may be one or more of the following:

• The ECU in the power window regulator motor determines that the power window regulator motor has not been initialized.

• The power window regulator switch has a malfunction.

• The Hall-IC in the power window regulator motor has a malfunction.

• There is an open or short in the wiring between the power window regulator switch and the passenger side power window regulator motor.

INSPECTION PROCEDURE

PROCEDURE

1. Click here

   CHECK FOR DTC

   
   

   1. Check for DTCs (Click here).

      Table 1. Result

      Result	Proceed to
      DTC is not output	A
      B2311 is output	B
      B2312 is output	C
      B2313 is output	D
      LIN communication system DTCs are output	E

   
   
   • AClick here
   • BClick here
   • CClick here
   • DClick here
   • EClick here
2. Click here

   CHECK MANUAL UP/DOWN FUNCTION (POWER WINDOW REGULATOR SWITCH)

   
   

   1. Check that the front passenger side door power window moves when the manual up/down function of the power window regulator switch is operated (Click here).

      OK
      front passenger side door power window moves.

   
   
   • OKClick here
   • NGClick here
3. Click here

   READ VALUE USING INTELLIGENT TESTER (FRONT POWER WINDOW REGULATOR MOTOR RH)

   
   

   1. Use the Data List to check if the power window regulator motor is functioning properly (Click here).

      Table 2. P-Door Motor

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      P Door P/W Auto SW	Front passenger side power window auto up/down signal / ON or OFF	ON: Front passenger side power window auto up/down switch operated OFF: Front passenger side power window switch not operated	-

      OK
      The display changes according to operation of the power window regulator switch.

   
   
   • OKClick here
   • NGClick here
4. Click here

   CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH - FRONT POWER WINDOW REGULATOR MOTOR)

   
   
   1. 

      Disconnect the I3*1 or I25*2 switch connector.

      Tip:
      

      • *1: for LHD

      • *2: for RHD

   2. Disconnect the I4*1 or I12*2 motor connector.

      Tip:
      

      • *1: for LHD

      • *2: for RHD

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Table 3. for LHD Tester Connection Condition Specified Condition I3-8 (AUTO) - I4-4 (AUTO) Always Below 1 Ω I3-8 (AUTO) or I4-4 (AUTO) - Body ground Always 10 kΩ or higher
      Table 4. for RHD Tester Connection Condition Specified Condition I25-8 (AUTO) - I12-4 (AUTO) Always Below 1 Ω I25-8 (AUTO) or I12-4 (AUTO) - Body ground Always 10 kΩ or higher

   
   
   • OKClick here
   • NGClick here
5. Click here

   INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY

   
   

   1. Remove the power window regulator switch (Click here).

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Table 5. for LHD Tester Connection Switch Condition Specified Condition I3-8 (AUTO) - I3-1 (GND) Auto up/down operation Below 1 Ω
      Table 6. for RHD Tester Connection Switch Condition Specified Condition I25-8 (AUTO) - I11-1 (GND) Auto up/down operation Below 1 Ω

      Table 7. Result

      Result	Proceed to
      NG	A
      OK (for LHD)	B
      OK (for RHD)	C

   
   
   • AClick here
   • BClick here
   • CClick here
6. Click here

   GO TO DTC B2311Click here

7. Click here

   GO TO DTC B2312Click here

8. Click here

   GO TO DTC B2313Click here

9. Click here

   GO TO LIN COMMUNICATION SYSTEMClick here

10. Click here

    OTHER PROBLEM (GO TO PROBLEM SYMPTOMS TABLE)Click here

11. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

12. Click here

    REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLYClick here

13. Click here

    REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RHClick here

14. Click here

    REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LHClick here