DISABLE AUTO TILT AWAY FUNCTION
Disable the Autoaway/Return function by changing the customize parameter Click here.
Note
Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.
Tech Tips
Performing the above operation causes the Autoaway/Return function to be disabled when the engine switch is turned off.
Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.
Turn the engine switch off.
REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
| *1 | Protective Tape |
Place protective tape as shown in the illustration.
Using a moulding remover, detach the 3 claws and remove the No. 1 instrument cluster finish panel garnish.
REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
Place protective tape as shown in the illustration.
Using a moulding remover, detach the 7 claws and remove the panel cushion.
REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
Remove the clip.
Remove the screw.
Detach the 8 claws.
Remove the panel pad and disconnect the connectors and 2 clamps.
REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Place protective tape as shown in the illustration.
Using a moulding remover, detach the 2 claws and remove the No. 2 instrument cluster finish panel garnish.
| *A | w/ Entry and Start System | *B | w/o Entry and Start System |
| *1 | Protective Tape | - | - |
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Detach the 9 claws.
Disconnect the connector and remove the instrument cluster finish panel.
REMOVE LIGHT CONTROL RHEOSTAT
Detach the 2 claws and remove the rheostat.