Click here

METER / GAUGE SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Click here
Click here Click here
Tip:

  • Use these procedures to troubleshoot the meter/gauge system.

  • *: Use the intelligent tester.


  1. Click here

    VEHICLE BROUGHT TO WORKSHOP


    • NEXT
  2. Click here

    INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.


    • NEXT
  3. Click here

    CHECK FOR DTC*


    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs. Based on the DTCs output above, try to force output of the same CAN communication system DTC or meter/gauge system DTC by simulating the symptoms indicated by the DTC.

      Table 1. Result
      Result Proceed to
      DTC is not output A
      CAN communication system (for LHD) DTC is output B
      CAN communication system (for RHD) DTC is output C
      Meter/gauge system DTC is output D

      • B
      • Go to CAN COMMUNICATION SYSTEM (See pageClick here)
      • C
      • Go to CAN COMMUNICATION SYSTEM (See pageClick here)
      • D
      • Go to DIAGNOSTIC TROUBLE CODE CHART (See pageClick here)
      • A
  4. Click here

    PROBLEM SYMPTOMS TABLE


    1. Refer to the Problem Symptoms Table (Click here).

      Table 2. Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

      • B
      • Go to step 6
      • A
  5. Click here

    OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Terminals of ECU (Click here)

    2. Data List / Active Test (Click here)

    3. Operation Check (Click here)


      • NEXT
  6. Click here

    REPAIR OR REPLACE


    • NEXT
  7. Click here

    CONFIRMATION TEST


    • NEXT
    • END