THEFT DETERRENT SYSTEM (w/ Entry and Start System) Intrusion Sensor Cancel Switch Circuit

DESCRIPTION

• When the intrusion sensor cancel switch on the map light is pressed, the sensor off signal is sent to the certification ECU (smart key ECU assembly) which causes the intrusion sensor to stop operating.

INSPECTION PROCEDURE

PROCEDURE

1. Click here

   READ VALUE USING INTELLIGENT TESTER (INTRUSION SENSOR CANCEL SWITCH)

   
   

   1. Using the intelligent tester, read the Data List.

      Table 1. Entry&Start

      Tester Display	Measurement Item / Display (Range)	Normal Condition	Diagnostic Note
      Intrusion sensor OFF	Intrusion sensor cancel switch / ON or OFF	ON: Intrusion sensor active (switch off) OFF: Intrusion sensor not active (switch on)	-

      OK
      ON (intrusion sensor active [switch off]) appears on screen.

   
   
   • OKClick here
   • NGClick here
2. Click here

   CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - MAP LIGHT ASSEMBLY)

   
   

   1. Disconnect the E30 ECU connector.

   2. Disconnect the R7 light connector.

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition E30-5 (SSW1) - R7-11 (SOFF) Always Below 1 Ω E30-5 (SSW1) or R7-11 (SOFF) - Body ground Always 10 kΩ or higher

   
   
   • OKClick here
   • NGClick here
3. Click here

   CHECK MAP LIGHT ASSEMBLY (INTRUSION SENSOR CANCEL SWITCH [OPERATION])

   
   

   1. Temporarily replace the map light assembly (intrusion sensor cancel switch) with a new or normally functioning one (Click here).

   2. Turn the intrusion sensor off by pressing the intrusion sensor cancel switch. Check if the switch operates normally by checking that the theft deterrent system does not operate when you move your hand in front of the sensor.

      OK
      Intrusion sensor cancel switch operates normally.

   
   
   • OKClick here
   • NGClick here
4. Click here

   REPAIR OR REPLACE HARNESS OR CONNECTOR

5. Click here

   REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

6. Click here

   END (MAP LIGHT [INTRUSION SENSOR CANCEL SWITCH] IS FAULTY)