ELECTRICAL KEY OSCILLATOR (for Front Floor) REMOVAL

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.


  1. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION


    1. A015BCWE02

      Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 7 claws and remove the panel cushion.

  2. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH


    1. A015D40

      Remove the clip.

    2. Remove the screw.

    3. Detach the 8 claws.

    4. Remove the panel pad and disconnect the connectors and 2 clamps.

  3. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION


    1. A015CGBE01

      Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 7 claws and remove the panel cushion.

  4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH


    1. A015BRH

      Remove the clip.

    2. Remove the screw.

    3. Detach the 7 claws and remove the panel.

  5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    1. Twist the shift lever knob in the direction indicated by the arrow and remove it.

      A0156X3E01

  6. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01574Y

      Detach the 7 claws.

    2. Disconnect the connectors and remove the panel.

  7. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A015C68

      Detach the 9 claws and remove the panel.

  8. REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY


    1. A015CM5

      Detach the 4 claws and remove the box.

  9. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A015CZ0

      Detach the 14 claws.

    2. Disconnect the connectors and remove the console panel.

  10. REMOVE INDOOR ELECTRICAL KEY OSCILLATOR


    1. A015E1A

      Disconnect the connector.

    2. Detach the 2 claws and remove the electrical key oscillator.