ENTRY AND START SYSTEM (for Start Function) HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use these procedures to troubleshoot the push-button start function.

  • *: Use the intelligent tester.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.


    NEXT

  3. INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Using the intelligent tester, check if the CAN communication system is functioning normally.


      • For LHD vehicles, use the following procedures Click here.

      • For RHD vehicles, use the following procedures Click here.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output (for LHD) B
      DTC is output (for RHD) C

      B

      GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here

      C

      GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here

      A

  4. CHECK FOR DTC*


    1. Check for DTCs and note any stored DTCs Click here.

    2. Clear the DTCs.

    3. Check whether the same DTC(s) relevant to the SFI system, EDU system or entry and start system recurs by reproducing the symptoms indicated by the noted DTC(s) in the first step above.

      Result
      Result Proceed to
      DTC output does not reoccur A
      SFI system DTC output reoccurs (for 1GR-FE) B
      SFI system DTC output reoccurs (for 1UR-FE) C
      SFI system DTC output reoccurs (for 3UR-FE) D
      ECD system DTC output reoccurs (for 1VD-FTV w/o DPF) E
      ECD system DTC output reoccurs (for 1VD-FTV w/ DPF) F
      Entry and start system DTC output reoccurs G

      B

      GO TO SFI SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here

      C

      GO TO SFI SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here

      D

      GO TO SFI SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here

      E

      GO TO ECD SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here

      F

      GO TO ECD SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here

      G

      GO TO STEP 7
      A

  5. PROBLEM SYMPTOMS TABLE

    Result
    Result Proceed to
    Fault is not listed in problem symptoms table A
    Fault is listed in problem symptoms table B

    B

    GO TO STEP 7
    A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Terminals of ECU Click here

    2. Data List / Active Test Click here


      NEXT

  7. ADJUST, REPAIR OR REPLACE


    NEXT

  8. CONFIRMATION TEST


    NEXT
    END