BACK DOOR LOCK (for Double Swing Out Type) INSPECTION


  1. INSPECT BACK DOOR LOCK ASSEMBLY


    1. A015698E01
      Text in Illustration
      *a Lock
      *b Unlock
      *c

      Component without harness connected

      (Back Door Lock Assembly)

      Check the operation of the door lock motor.


      1. Apply battery voltage to the door lock motor connector and check the operation of the door lock motor.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → Terminal 2 (ACT+)

        Battery negative (-) → Terminal 3 (ACT-)

        		 Lock

        Battery positive (+) → Terminal 3 (ACT-)

        Battery negative (-) → Terminal 2 (ACT+)

        		 Unlock

        If the result is not as specified, replace the back door lock assembly.

    2. Check the detection switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        1 (S) - 4 (E) Lock 10 kΩ or higher
        Unlock Below 1 Ω

        If the result is not as specified, replace the back door lock assembly.

    3. Check the operation of the door courtesy switch.

      A015CG1E01
      Text in Illustration
      *a

      Component without harness connected

      (Back Door Lock Assembly)

      		 *b Full Latch
      *c Half Latch *d Open

      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 (E) - 2 (+) Open Below 1 Ω
        Half Latch Below 1 Ω
        Full Latch 10 kΩ or higher

        If the result is not as specified, replace the back door lock assembly.