REAR DOOR LOCK REMOVAL

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY LH


    1. A015ALM

      Using a moulding remover, detach the 7 claws.

    2. Disconnect the connector and remove the armrest base panel.

  4. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH


    1. A015B1YE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 4 claws and remove the rear door inside handle bezel LH.

      Tech Tips

      Tape the screwdriver tip before use.

  5. REMOVE ASSIST GRIP COVER LH


    1. A015D94

      Using a moulding remover, detach the 9 claws and remove the assist grip cover LH.

  6. REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)


    1. A015B9E

      Detach the claw.

    2. Remove the courtesy light and then disconnect the connector.

  7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A0155STE01

      Remove the 3 screws.

    2. Remove the 9 clips.

    3. Remove the rear inner door glass weatherstrip LH together with the rear door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.

      Tech Tips

      Make sure that the pin labeled A in the illustration is detached from the door panel.

    4. Disconnect the connector and remove the rear door trim board sub-assembly LH.

    5. A0159D6

      Disconnect the 2 cables from the rear door inside handle sub-assembly LH.

  8. REMOVE REAR DOOR SERVICE HOLE COVER LH


    1. A0158QNE01

      Using a clip remover, detach the 6 clamps.

    2. Remove the bolt and disconnect the 2 connectors.

    3. Remove the rear door service hole cover LH.

      Tech Tips

      Remove the remaining tape on the door.

  9. REMOVE REAR DOOR LOCK ASSEMBLY LH


    1. A0157TY

      Using a T30 ''TORX'' socket, remove the 3 screws and door lock.

      Note

      Be careful when removing the screws as the door lock may fall and become damaged.

  10. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH


    1. A015BC1E01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the claw.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A0159Y6

      Remove the rear door lock remote control cable assembly LH.

  11. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH


    1. A015948E01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 3 claws.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A015745E03
      Text in Illustration
      *A w/o Double Lock
      *B w/ Double Lock

      Remove the rear door inside locking cable assembly LH.