DOOR CONTROL SWITCH INSPECTION


  1. INSPECT DOOR CONTROL SWITCH ASSEMBLY


    1. A015AEDE06
      Text in Illustration
      *a Unlock
      *b Lock
      *c

      Component without harness connected

      (Door Control Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      2 (UL) - 3 (E) Unlock Below 1 Ω
      2 (UL) - 3 (E) Off 10 kΩ or higher
      4 (L) - 3 (E)
      4 (L) - 3 (E) Lock Below 1 Ω

      • If the result is not as specified, replace the door control switch assembly.

    2. A015AWKE02
      Text in Illustration
      *a

      Component without harness connected

      (Door Control Switch Assembly)

      Apply battery voltage to the switch connector and check that the indicator (LED) illuminates.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 1 (IG)

      Battery negative (-) → Terminal 3 (E)

      		 Indicator (LED) illuminates

      If the result is not as specified, replace the door control switch assembly.