Click here

CAN COMMUNICATION SYSTEM (for RHD), Diagnostic DTC:U0132

Click here
Click here Click here
DTC Code DTC Name
U0132 Lost Communication with Ride Level Control Module
Click here

DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
U0132 There is no communication from the suspension control ECU.

  • Power source circuit of suspension control ECU

  • Suspension control ECU CAN branch wire or connector

  • Suspension control ECU

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Tip:

Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.

      CAUTION:

      For vehicles with an SRS system:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


  3. Click here

    CHECK FOR OPEN IN CAN BUS WIRE (SUSPENSION CONTROL ECU CAN BRANCH WIRE)


    1. A0158KXE04

      Disconnect the K34 suspension control ECU connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      K34-7 (CANH) - K34-8 (CANL) Ignition switch off 54 to 69 Ω
      Table 1. Text in Illustration
      *a

      Rear view of wire harness connector

      (to Suspension Control ECU)

  4. Click here

    CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - BATTERY AND BODY GROUND)


    1. A0158QCE08

      Connect the cable to the negative (-) battery terminal.

      Note:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

    2. Disconnect the K35 suspension control ECU connector.

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      K35-1 (BAT) - Body ground Always 11 to 14 V
      K34-3 (BAT2) - Body ground Always 11 to 14 V
      K34-5 (IG) - Body ground Ignition switch ON 11 to 14 V

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      K34-1 (GND) - Body ground Always Below 1 Ω
      K35-6 (GND) - Body ground Always Below 1 Ω
      Table 2. Text in Illustration
      *a

      Rear view of wire harness connector

      (to Suspension Control ECU)

  5. Click here

    REPAIR OR REPLACE SUSPENSION CONTROL ECU BRANCH WIRE OR CONNECTOR (CANH, CANL)

  6. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  7. Click here

    REPLACE SUSPENSION CONTROL ECUClick here