REAR VIEW MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips

Use the following procedures to troubleshoot the rear view monitor system.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. CUSTOMER PROBLEM ANALYSIS


    NEXT

  3. INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, replace or recharge the battery before proceeding.


    NEXT

  4. CHECK DTC OF NAVIGATION SYSTEM


    1. Refer to the DTC Check / Clear procedures of the navigation system Click here.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

      B

      Go to NAVIGATION SYSTEM Click here

      A

  5. PROBLEM SYMPTOM CONFIRMATION

    Result
    Result Proceed to
    Symptom does not occur A
    Symptom occurs B

    A

    Go to step 7
    B

  6. SYMPTOM SIMULATION


    NEXT

  7. CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM

    Result
    Result Proceed to
    Symptom does not appear A
    Symptom appears (Audio and Visual System [w/ Navigation System]) B
    Symptom appears (Navigation System) C
    Symptom appears (Rear Seat Entertainment System) D

    B

    Go to AUDIO AND VISUAL SYSTEM (w/ Navigation System)
    C

    Go to NAVIGATION SYSTEM
    D

    G0 to REAR SEAT ENTERTAINMENT SYSTEM
    A

  8. PROBLEM SYMPTOMS TABLE


    1. Refer to the Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

      B

      ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
      A

  9. BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW


    1. Terminals of ECU Click here.


      NEXT

  10. ADJUST, REPAIR OR REPLACE


    NEXT

  11. CONFIRMATION TEST


    NEXT
    END