Click here

PARKING ASSIST MONITOR SYSTEM (w/o Side Monitor System), Diagnostic DTC:C1622

Click here
Click here Click here
DTC Code DTC Name
C1622 Back Camera Disconnected
Click here

DESCRIPTION

This DTC is stored if the multi-media module receiver assembly judges that the signals or signal lines between the multi-media module receiver assembly and the rear television camera assembly are not normal as a result of its self check.

DTC Code DTC Detection Condition Trouble Area
C1622 Open or short in the rear television camera assembly signal circuit

  • Harness or connector

  • Rear television camera assembly

  • Multi-media module receiver assembly
Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

  • When "System initializing" is displayed on the multi-media module receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/o Side Monitor System) may be needed (Click here).

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER - REAR TELEVISION CAMERA AND BODY GROUND)


    1. Disconnect the F77 multi-media module receiver assembly connector.

    2. Disconnect the S5 rear television camera assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F77-18 (V+) - S5-2 (CV+) Always Below 1 Ω
      F77-19 (V-) - S5-1 (CV-) Always Below 1 Ω
      F77-39 (CA+) - S5-4 (CB+) Always Below 1 Ω
      F77-40 (CGND) - S5-3 (CGND) Always Below 1 Ω
      F77-12 (GND1) - Body ground Always Below 1 Ω
      F77-18 (V+) - Body ground Always 10 kΩ or higher
      F77-19 (V-) - Body ground Always 10 kΩ or higher
      F77-39 (CA+) - Body ground Always 10 kΩ or higher
      F77-40 (CGND) - Body ground Always 10 kΩ or higher

  2. Click here

    CHECK MULTI-MEDIA MODULE RECEIVER ASSEMBLY (CA+, CGND)


    1. A015BYQE03

      Reconnect the multi-media module receiver assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F77-40 (CGND) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      F77-39 (CA+) - F77-40 (CGND) Engine switch on (IG), shift lever in R 5.5 to 7.05 V
      Table 1. Text in Illustration
      *a

      Component with harness connected

      (Multi-media Module Receiver Assembly)

  3. Click here

    CHECK REAR TELEVISION CAMERA ASSEMBLY (CV+, CGND)


    1. A015C8YE02

      Reconnect the S5 rear television camera assembly connector.

      Table 2. Text in Illustration
      *a

      Component with harness connected

      (Multi-media Module Receiver Assembly)

      		 *b Waveform A
      *c Waveform A *d Synchronization Signal
      *e Video Waveform - -

    2. Check the waveform of the rear television camera assembly using an oscilloscope.

      Tip:

      • A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the multi-media module receiver assembly with the connector connected.

      • The video waveform changes according to the image sent by the rear television camera assembly.

      Table 3. Measurement Condition
      Item Content
      Tester No. (Symbol) F77-18 (V+) - F77-40 (CGND)
      Tool Setting 0.2 V/DIV., 50 μS/DIV
      Condition

      Waveform A: Engine starts, shift lever in R (camera lens is not covered, displaying an image)

      Waveform B: Engine starts, shift lever in R (camera lens is covered, blacking out the screen)
      OK
      Waveform is as shown in the illustration.

  4. Click here

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLYClick here

  5. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  6. Click here

    REPLACE REAR TELEVISION CAMERA ASSEMBLYClick here