Click here

INSTRUMENT PANEL SPEAKER INSTALLATION

Click here
Click here Click here
Tip:

  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart (Click here).

Click here
  1. Click here

    INSTALL FRONT NO. 2 SPEAKER ASSEMBLY


    1. A0156KZ

      for 9 Speakers Models:


      1. Connect the connector.

      2. Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.

      3. Install the speaker with the 2 bolts.

        Note:

        • Do not touch the cone part of the speaker.

        • When installing the speaker to the instrument panel be careful that the wires do not get caught between the parts.

    2. A015CTNE01

      except 9 Speakers Models:


      1. Connect the connector.

      2. Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.

      3. Install the speaker with the 2 bolts.

        Note:

        • Do not touch the cone part of the speaker.

        • When installing the speaker to the instrument panel be careful that the wires do not get caught between the parts.

  2. Click here

    INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


    1. Attach the 4 claws to install the panel.

  3. Click here

    INSTALL FRONT PILLAR GARNISH LH


    1. for 9, 14 Speakers:

      Connect the speaker connector.

    2. Attach the clip and 3 guides to install the front pillar garnish.

  4. Click here

    INSTALL FRONT ASSIST GRIP SUB-ASSEMBLY

    Tip:

    Use the same procedure to install the front assist grip on the other side.


    1. Attach the 2 claws to install the front assist grip.

    2. Install the 2 bolts.

    3. A0157N5

      Attach the 4 claws to install the 2 assist grip plugs.

  5. Click here

    INSTALL FRONT NO. 4 SPEAKER ASSEMBLY


    1. Connect the speaker connector.

    2. Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.

    3. A0157JN

      Install the speaker with the 2 bolts.

      Note:

      • Do not touch the cone part of the speaker.

      • When installing the speaker to the instrument panel be careful that the wires do not get caught between the parts.

  6. Click here

    INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY


    1. Attach the 8 claws to install the opening cover.

  7. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).