INSTRUMENT PANEL SPEAKER REMOVAL

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

    A015A0J

    1. Detach the 8 claws and remove the opening cover.

  4. REMOVE FRONT NO. 4 SPEAKER ASSEMBLY

    A0157JN

    1. Remove the 2 bolts.

    2. Remove the speaker and then disconnect the speaker connector.

      Note

      Do not touch the cone part of the speaker.

  5. REMOVE FRONT ASSIST GRIP SUB-ASSEMBLY

    A0157N5

    Tech Tips

    Use the same procedure to remove the front assist grip on the other side.


    1. Detach the 4 claws and remove the 2 assist grip plugs.

    2. A0156G7

      Remove the 2 bolts.

    3. Detach the 2 claws and remove the front assist grip.

  6. REMOVE FRONT PILLAR GARNISH LH

    A015DZB

    1. Detach the clip and 3 guides, and remove the front pillar garnish.

    2. for 9, 14 Speakers:

      Disconnect the speaker connector and then remove the front pillar garnish.

    3. A015CWJE01

      Protect the curtain shield airbag.


      1. Thoroughly cover the airbag with a cloth or nylon sheet and fix the ends of the cover with adhesive tape, as shown in the illustration.

        Note

        Cover the curtain shield airbag with a protective cover as soon as the front pillar garnish is removed.

  7. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


    1. A0156E3

      Detach the 4 claws and remove the speaker panel.

  8. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    1. A0156KZ

      for 9 Speakers Models:


      1. Remove the 2 bolts.

      2. Remove the speaker and then disconnect the speaker connector.

        Note

        Do not touch the cone part of the speaker.

    2. except 9 Speakers Models:

      A015CTNE01

      1. Remove the 2 bolts.

      2. Remove the speaker and then disconnect the speaker connector.

        Note

        Do not touch the cone part of the speaker.