REAR SEAT ENTERTAINMENT SYSTEM Display Signal Circuit between Radio Receiver and Television Display Assembly

DESCRIPTION

This is the display signal circuit from the multi-media module receiver assembly to the television display assembly.

INSPECTION PROCEDURE

PROCEDURE

1. Click here

   CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)

   
   

   1. Disconnect the F78 multi-media module receiver assembly connector.

   2. Disconnect the L53 television display assembly connector.

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition F78-1 (NTSO) - L53-20 (NTS4) Always Below 1 Ω F78-2 (NTSG) - L53-19 (SGN4) Always Below 1 Ω F78-3 (SLD2) - L53-18 (SLD4) Always Below 1 Ω F78-1 (NTSO) - Body ground Always 10 kΩ or higher F78-2 (NTSG) - Body ground Always 10 kΩ or higher F78-3 (SLD2) - Body ground Always 10 kΩ or higher

   
   
   • OKClick here
   • NGClick here
2. Click here

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

3. Click here

   REPAIR OR REPLACE HARNESS OR CONNECTOR