AUDIO AND VISUAL SYSTEM (w/o Navigation System), Diagnostic DTC:01-D5, 01-D8, 01-D9, 01-DA, 01-DB, 01-DE

DTC Code DTC Name
01-D5 Absence of Registration Unit
01-D8 No Response for Connection Check
01-D9 Last Mode Error
01-DA No Response Against ON / OFF Command
01-DB Mode Status Error
01-DE Slave Reset

DESCRIPTION

DTC No. DTC Detection Condition Trouble Area

01-D5

*1, *3

A device indicated by the sub-code is (was) disconnected from the system while the engine switch on (IG) or (ACC).

The communication condition with the device that the DTC shows cannot be obtained when the engine starts.


  • Power source circuit of the component shown by the sub-code


  • AVC-LAN circuit between the radio receiver assembly and component shown by the sub-code


  • Component shown by the sub-code

01-D8

*2, *3

The device indicated by the sub-code is (was) disconnected from the system after the engine starts.

01-D9

*1, *3

The device that had functioned before the engine stopped is (was) disconnected from the system while the engine switch on (IG) or (ACC).

01-DA

*3

No response is identified when changing mode.

Sound and image do not change by switch operation.

01-DB

*1, *3

A dual alarm is detected.

01-DE

*3, *4

A slave device has been disconnected after the engine starts.

Tech Tips


  • *1: Even if no fault is present, this DTC may be stored depending on the battery condition or engine start voltage.

  • *2: If the power connector is disconnected after the engine starts, this DTC is stored after 180 seconds.

  • *3: If the device is reported as not existing during verification, check the power source circuit and AVC-LAN circuit for the device.

  • *4: This DTC may be stored if the engine is started and the engine switch start again.

Note


  • Before starting troubleshooting, be sure to clear the DTCs stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.

  • The radio receiver assembly is the master unit.

  • Be sure to clear and recheck for the DTCs after the inspection is completed to confirm that no DTCs are output.

INSPECTION PROCEDURE

Note

Be sure to read Description before performing the following procedure.

PROCEDURE


  1. CHECK "RADIO RECEIVER COMMUNICATION ERROR" IN FLOW CHART

    Tech Tips

    Refer to Radio Receiver Communication Error Click here.


    NEXT