Click here

STEERING LINKAGE REASSEMBLY

Click here
Click here Click here
  1. Click here

    INSTALL STEERING RACK END SUB-ASSEMBLY


    1. Temporarily install the 2 steering rack ends to the power steering rack.

    2. Fill up the ball joint of the steering rack ends with MP grease.

    3. A0158RKE01

      Using SST, install the power steering rack end (RH side) to the power steering rack.

      09922-10010
      without SST
      147 N*m 1499 kgf*cm 108 ft.*lbf
      with SST
      110 N*m 1122 kgf*cm 81 ft.*lbf
      Tip:

      • Rotate SST in the direction shown in the illustration.

      • Use a torque wrench with a fulcrum length of 380 mm (14.97 in.).

    4. Using SST and a wrench, install the power steering rack end (LH side) to the power steering rack.

      09922-10010
      without SST
      147 N*m 1499 kgf*cm 108 ft.*lbf
      with SST
      110 N*m 1122 kgf*cm 81 ft.*lbf
      Tip:

      • Rotate SST in the direction shown in the illustration.

      • Use a torque wrench with a fulcrum length of 380 mm (14.97 in.).

  2. Click here

    INSTALL NO. 1 STEERING RACK BOOT


    1. Apply silicon grease to the inside of the small opening of the boot.

    2. Install the 2 boots to the groove on the rack housing.

  3. Click here

    INSTALL STEERING RACK BOOT CLAMP RH


    1. Using SST, install a new boot clamp as shown in the illustration.

      09521-24010
      Standard clearance
      3.0 mm (0.119 in.) or less
      Note:

      Be careful not to damage the boot.

  4. Click here

    INSTALL STEERING RACK BOOT CLAMP LH

    Tip:

    Use the same procedures described for the RH side.

  5. Click here

    INSTALL STEERING RACK BOOT CLIP RH


    1. Using pliers, install the boot clip.

      Note:

      Make sure that the claws of each clip are positioned within the area shown in the illustration.

  6. Click here

    INSTALL STEERING RACK BOOT CLIP LH

    Tip:

    Use the same procedures described for the RH side.