Click here

STEERING HEATER SWITCH REMOVAL

Click here
Click here Click here
Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

Click here
  1. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. Click here

    REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION


    1. Put protective tape around the No. 2 instrument panel finish panel cushion.

      Table 1. Text in Illustration
      *1 Protective Tape

    2. Using a moulding remover, detach the 7 claws and remove the No. 2 instrument panel finish panel cushion.

  3. Click here

    REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH


    1. A015D40

      Remove the clip.

    2. Remove the screw.

    3. Detach the 8 claws.

    4. Remove the panel pad and disconnect the connectors and 2 clamps.

  4. Click here

    REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. Place protective tape as shown in the illustration.

      Table 2. Text in Illustration
      *1 Protective Tape

    2. Using a moulding remover, detach the 3 claws and remove the No. 1 instrument cluster finish panel garnish.

  5. Click here

    REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. Place protective tape as shown in the illustration.

    2. A0159Y8E01

      Using a moulding remover, detach the 2 claws and remove the No. 2 instrument cluster finish panel garnish.

      Table 3. Text in Illustration
      *A w/ Entry and Start System *B w/o Entry and Start System
      *1 Protective Tape - -
  6. Click here

    REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Remove the 2 screws.

    2. Detach the 3 claws.

    3. Disconnect the connectors and remove the No. 1 instrument panel under cover.

  7. Click here

    REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. Using a screwdriver, detach the 2 claws and open the hole cover.

      Tip:

      Tape the screwdriver tip before use.

      Table 4. Text in Illustration
      *1 Protective Tape

    2. w/ Driver Side Knee Airbag:


      1. Remove the 2 bolts.

      2. A015CUJ

        Detach the 16 claws.

    3. w/o Driver Side Knee Airbag:


      1. Remove the 2 bolts.

      2. A015A9A

        Detach the 9 claws.

    4. A0158MF

      for Automatic Air Conditioning System:


      1. Detach the 2 claws and remove the room temperature sensor.

    5. A0156SA

      Detach the 2 claws and disconnect the 2 control cables.

    6. Disconnect the connectors and remove the lower No. 1 instrument panel finish panel.

  8. Click here

    REMOVE NO. 1 SWITCH HOLE BASE


    1. Using a screwdriver, detach the 4 claws and remove the switch.

      Tip:

      Tape the screwdriver tip before use.

  9. Click here

    REMOVE STEERING HEATER SWITCH


    1. A0156YO

      Detach the 2 claws to remove the steering heater switch from the lower instrument panel finish panel sub-assembly.