POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM Actuator Power Source Circuit

DESCRIPTION

This is the power source for the motors.

WIRING DIAGRAM

A015E3RE03

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT FUSE (TI & TE)


    1. Remove the TI & TE fuse from the main body ECU.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      TI & TE fuse Always Below 1 Ω

    NG

    REPLACE FUSE

    OK

  2. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY)


    1. A015ADWE21

      Disconnect the E27 multiplex tilt and telescopic ECU connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      E27-2 (+B) - Body ground Always 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND)


    1. A015ADWE22

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E27-11 (GND) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    CHECK IG POWER SOURCE CIRCUIT Click here