VANE PUMP (for 1GR-FE) REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A0159TNE01
      Text in Illustration
      *1 Pin
      *2 Hook

      Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

  4. REMOVE FAN AND GENERATOR V BELT


    1. A0157ZV

      While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar with a diameter of 6 mm (0.236 in.) into the service hole to fix the belt tensioner in place.

      Tech Tips

      The pulley bolt for the belt tensioner has a left-hand thread.

    2. Remove the V belt.

  5. DRAIN POWER STEERING FLUID

  6. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR

    A015DBG

    1. Disconnect the connector.

    2. Detach the wire harness clamp from the bracket.

  7. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

    A01595K

    1. Slide the clip and disconnect the No.1 oil reservoir to pump hose from the vane pump.

  8. DISCONNECT PRESSURE FEED TUBE


    1. A015BOK

      Remove the union bolt and disconnect the pressure feed tube.

    2. Remove the gasket.

  9. REMOVE VANE PUMP ASSEMBLY

    A015AMFE01

    1. Remove the 2 bolts and vane pump.