PARKING BRAKE ASSEMBLY REASSEMBLY

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.


  1. INSTALL PARKING BRAKE ANCHOR BLOCK


    1. A0156CI

      Install the anchor block with the 2 nuts.

      Torque:
      86 N*m  { 877 kgf*cm, 63 ft.*lbf }

  2. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY


    1. A015636

      Connect the No. 3 parking brake cable with the bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  3. INSTALL PARKING BRAKE SHOE LEVER LH


    1. A01577ZE01

      Apply high temperature grease to the parking brake anchor block.

    2. Install the parking brake shoe lever to the No. 3 parking brake cable.

      Note

      Be carefully to distinguish between the parking brake shoe lever RH and LH.

  4. INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY LH


    1. Apply high temperature grease to the areas of the backing plate that contact the shoe.

    2. A01570ME01

      Using SST, install the No. 2 parking brake shoe with the shoe hold down spring pin, compression spring and shoe hold down spring cup.

      SST
      09718-00011

  5. INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY LH


    1. Apply high temperature grease to the areas of the backing plate that contact the shoe.

    2. A015BATE01

      Apply high temperature grease to the thread and all joining areas of the parking brake shoe adjuster screw set.

    3. A015E3N

      Set the No. 1 parking brake shoe and shoe adjuster screw set in place.

    4. A01579B

      Connect the tension spring.

    5. A0156PXE01

      Using SST, install the shoe hold down spring pin, compression spring and shoe hold down spring cup.

      SST
      09718-00011

  6. INSTALL PARKING BRAKE SHOE RETURN SPRING


    1. A015B5EE01

      Using SST, install the shoe return spring.

      SST
      09703-30011

  7. CHECK PARKING BRAKE INSTALLATION


    1. Check that each part is installed properly.

      A0155E6E01

  8. INSTALL REAR DISC


    1. A015ALXE01

      While aligning the matchmarks, install the rear disc.

  9. CONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH


    1. A015DKT

      Connect the rear disc brake cylinder with 2 new bolts.

      Torque:
      95 N*m  { 969 kgf*cm, 70 ft.*lbf }

      Note


      • Do not twist the brake hose.

      • Make sure that the bolts are free from damage and foreign matter.

      • Do not overtighten the bolts.

  10. ADJUST PARKING BRAKE

    Click here

  11. INSTALL REAR WHEEL LH

    Torque:
    for Aluminum Wheel
    131 N*m  { 1336 kgf*cm, 97 ft.*lbf }
    for Steel Wheel
    209 N*m  { 2131 kgf*cm, 154 ft.*lbf }