CRAWL SWITCH INSPECTION


  1. CHECK SUSPENSION CONTROL SWITCH (CRAWL SWITCH)

    A015DKQE01
    Text in Illustration
    *1 CRAWL ON/OFF Switch
    *2 Turn Assist Function Switch
    *3 CRAWL Speed Selector Switch
    *a

    Component without harness connected:

    (CRAWL Switch)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      18 (ECU1) - 16 (E) Speed selector switch: Medium 10 kΩ or higher
      Speed selector switch: Medium-high
      Speed selector switch: High
      Speed selector switch: Low Below 1 Ω
      Speed selector switch: Medium-low
      19 (ECU2) - 16 (E) Speed selector switch: Medium-low 10 kΩ or higher
      Speed selector switch: Medium
      Speed selector switch: Medium-high
      Speed selector switch: Low Below 1 Ω
      Speed selector switch: High
      13 (ECU3) - 16 (E) Speed selector switch: Low 10 kΩ or higher
      Speed selector switch: Medium-low
      Speed selector switch: Medium
      Speed selector switch: Medium-high Below 1 Ω
      Speed selector switch: High
      14 (HSW) - 16 (E) ON/OFF switch: Pressed Below 1 Ω
      ON/OFF switch: Not pressed 10 kΩ or higher
      2 (OTA) - 16 (E) Turn assist function switch: Pressed Below 1 Ω
      Turn assist function switch: Not pressed 10 kΩ or higher

      If the result is not as specified, replace the suspension control switch (CRAWL switch).