Click here

SKID CONTROL BUZZER INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL SKID CONTROL BUZZER ASSEMBLY (for LHD)


    1. A0156O0

      Connect the buzzer connector.

      Note:

      Securely connect the connector.

    2. Attach the clamp to install the buzzer.

      Note:

      • Securely insert the clamp into the bracket.

      • If the buzzer is dropped, replace it.

  2. Click here

    INSTALL SKID CONTROL BUZZER ASSEMBLY (for RHD)


    1. A015BMT

      Connect the buzzer connector.

      Note:

      Securely connect the connector.

    2. Attach the clamp to install the buzzer.

      Note:

      • Securely insert the clamp into the bracket.

      • If the buzzer is dropped, replace it.

  3. Click here

    INSTALL NO. 1 SWITCH HOLE BASE


    1. Connect the connectors.

    2. Attach the 4 claws to install the No. 1 switch hole base.

  4. Click here

    INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. Connect the connectors.

    2. A0158MF

      for Automatic Air Conditioning System:


      1. Attach the 2 claws to install the room temperature sensor.

    3. A0156SA

      Attach the 2 claws to connect the 2 control cables.

    4. w/ Driver Side Knee Airbag:


      1. Attach the 16 claws to install the lower No. 1 instrument panel finish panel.

      2. A015CUJ

        Install the 2 bolts.

    5. w/o Driver Side Knee Airbag:


      1. Attach the 9 claws to install the lower No. 1 instrument panel finish panel.

      2. A015A9A

        Install the 2 bolts.

    6. A015ATT

      Attach the 2 claws to close the hole cover.

  5. Click here

    INSTALL COWL SIDE TRIM BOARD


    1. Attach the 2 clips to install the cowl side trim board.

    2. Install the cap nut.

  6. Click here

    INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Connect the connectors.

    2. Attach the 3 claws to install the No. 1 instrument panel under cover.

    3. Install the 2 screws.

  7. Click here

    INSTALL FRONT DOOR SCUFF PLATE

  8. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).