SKID CONTROL BUZZER REMOVAL

PRECAUTION

Note

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE FRONT DOOR SCUFF PLATE
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
1. Remove the 2 screws.
2. Detach the 3 claws.
3. Disconnect the connectors and remove the No. 1 instrument panel under cover.
REMOVE COWL SIDE TRIM BOARD
1. Remove the cap nut.
2. Detach the 2 clips and remove the cowl side trim board.
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
1. Using a screwdriver, detach the 2 claws and open the hole cover.
  
  Tech Tips
  
  Tape the screwdriver tip before use.
  
  Text in Illustration
  
  *1 Protective Tape
2. w/ Driver Side Knee Airbag:
  1. Remove the 2 bolts.
  2. Detach the 16 claws.
3. w/o Driver Side Knee Airbag:
  1. Remove the 2 bolts.
  2. Detach the 9 claws.
4. for Automatic Air Conditioning System:
  1. Detach the 2 claws and remove the room temperature sensor.
5. Detach the 2 claws and disconnect the 2 control cables.
6. Disconnect the connectors and remove the lower No. 1 instrument panel finish panel.
REMOVE NO. 1 SWITCH HOLE BASE
1. Detach the 4 claws.
2. Disconnect the connectors and remove the No. 1 switch hole cover.
REMOVE SKID CONTROL BUZZER ASSEMBLY (for LHD)
1. Detach the clamp and remove the buzzer.
2. Disconnect the buzzer connector.
REMOVE SKID CONTROL BUZZER ASSEMBLY (for RHD)
1. Detach the clamp and remove the buzzer.
2. Disconnect the buzzer connector.