Click here

REAR SPEED SENSOR REMOVAL

Click here
Click here Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE REAR WHEEL

  4. Click here

    REMOVE SKID CONTROL SENSOR WIRE


    1. A0158PC

      Disconnect the speed sensor LH connector.

    2. A015681E01

      Detach the 2 clamps and remove the bolt and sensor clamp.

    3. A01598H

      Detach the 5 clamps.

    4. A015596

      Detach the 3 clamps.

    5. A0156HL

      Disconnect the speed sensor RH connector.

    6. A0156U2E01

      Remove the bolt.

    7. A0157UOE01

      Disconnect the connector, and remove the bolt and skid control sensor wire.

  5. Click here

    REMOVE REAR SPEED SENSOR LH


    1. A01555A

      Remove the nut and speed sensor.

      Note:

      Pull out the sensor while trying as much as possible not to rotate it.

  6. Click here

    REMOVE REAR SPEED SENSOR RH


    1. A0158PJ

      Remove the nut and speed sensor.

      Note:

      Pull out the sensor while trying as much as possible not to rotate it.