Click here

FRONT SPEED SENSOR REMOVAL

Click here
Click here Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE FRONT WHEEL

  4. Click here

    REMOVE FRONT SKID CONTROL SENSOR WIRE LH


    1. A0158U2

      Disconnect the connector from the front speed sensor.

    2. Remove the bolt and harness clamp.

    3. Remove the nut and harness clamp.

    4. A0158LQ

      Remove the 2 bolts and 2 harness clamps.

    5. A015BXDE01

      w/o AHC:

      Disconnect the connector and then remove the bolt, harness clamp and sensor wire.

    6. A0159JWE01

      w/ AHC:

      Disconnect the 2 connectors and then remove the bolt, harness clamp and sensor wire.

  5. Click here

    REMOVE FRONT SPEED SENSOR LH


    1. A0158DQ

      Remove the bolt and speed sensor from the knuckle.

      Note:

      Pull out the sensor while trying as much as possible not to rotate it.

  6. Click here

    REMOVE FRONT SKID CONTROL SENSOR WIRE RH


    1. A015C9B

      Disconnect the connector from the front speed sensor.

    2. Remove the bolt and harness clamp.

    3. Remove the nut and harness clamp.

    4. w/o AHC:


      1. A015794

        Disconnect the connector.

      2. Detach the connector from the skid control sensor clamp.

      3. Remove the bolt and skid control sensor clamp.

      4. Remove the 2 bolts, 2 harness clamps and sensor wire.

    5. w/ AHC:


      1. A015C9W

        Disconnect the connector.

      2. Detach the connector from the skid control sensor clamp.

      3. Remove the bolt and skid control sensor clamp.

      4. Remove the 2 bolts and 2 harness clamps.

      5. A0158P7

        Disconnect the connector and then remove the bolt, harness clamp and sensor wire.

  7. Click here

    REMOVE FRONT SPEED SENSOR RH


    1. A015CSK

      Remove the bolt and speed sensor from the knuckle.

      Note:

      Pull out the sensor while trying as much as possible not to rotate it.