VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1442, C1443

DTC Code DTC Name
C1442 Invalid Data Received from Acceleration Sensor
C1443 Invalid Data Received from Yaw Rate Sensor

DESCRIPTION

The skid control ECU (master cylinder solenoid) receives signals from the yaw rate sensor assembly via the CAN communication system.

The yaw rate sensor assembly has a built-in acceleration sensor.

DTC Code DTC Detection Condition Trouble Area
C1442 An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more. Yaw rate sensor assembly
C1443 An invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more. Yaw rate sensor assembly

INSPECTION PROCEDURE

Note

After replacing the yaw rate sensor assembly, perform calibration Click here.

PROCEDURE


  1. CHECK DTC


    1. Clear the DTCs Click here.

    2. Turn the ignition switch off.

    3. Start the engine and idle it for 60 seconds, and then stop the engine.

    4. Check if the same DTC is output Click here.

      Result
      Result Proceed to
      DTC is output A
      DTC is not output B

    B

    CHECK FOR INTERMITTENT PROBLEMS Click here

    A

    REPLACE YAW RATE SENSOR ASSEMBLY Click here