VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1340

DTC Code DTC Name
C1340 Center Differential Lock Circuit

DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
C1340 An open circuit is detected in the EXI circuit of the skid control ECU.

  • Harness or connector

  • Transfer system

  • Skid control ECU (Master cylinder solenoid)

WIRING DIAGRAM

A015AR7E10

INSPECTION PROCEDURE

Note

After replacing the master cylinder solenoid, perform zero point calibration and store the system information Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (EXI TERMINAL)


    1. Turn the ignition switch off.

    2. Disconnect the skid control ECU (master cylinder solenoid) connector.

    3. A015D41E69
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Skid Control ECU [Master Cylinder Solenoid])

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      A24-27 (EXI) - Body ground Ignition switch ON 11 to 14 V

    NG

    Click here

    OK

  2. RECONFIRM DTC


    1. Clear the DTCs Click here.

    2. Turn the ignition switch off.

    3. Check for DTCs Click here.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output (for LHD) B
      DTC is output (for RHD) C

    B

    REPLACE MASTER CYLINDER SOLENOID Click here

    C

    REPLACE MASTER CYLINDER SOLENOID Click here

    A

    CHECK FOR INTERMITTENT PROBLEMS Click here

  3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - 4 WHEEL DRIVE CONTROL ECU/TRANSFER SHIFT ACTUATOR)


    1. Disconnect the A24 skid control ECU (master cylinder solenoid) connector.

    2. Disconnect the A27 4 wheel drive control ECU connector.

    3. Disconnect the C37 transfer shift actuator assembly connector.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A24-27 (EXI) - A27-14 (P1) Always Below 1 Ω
      A24-27 (EXI) - C37-3 (CDL) Always Below 1 Ω
      A24-27 (EXI) - Body ground Always 10 kΩ or higher
      C37-7 (GND1) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) Click here