REAR LATERAL CONTROL ROD REMOVAL

REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

1. 

   Detach the clamp, and disconnect the connector from the protector.

2. Remove the 3 bolts and protector.

OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

1. 

   Using a 5 mm hexagon socket wrench, loosen the lower and upper chamber shutter valves of the stabilizer control with accumulator housing 2.0 to 3.5 turns.

   Note:
   

   • When loosening a shutter valve, make sure that the end protrudes 2 to 3.5 mm (0.0787 to 0.137 in.) from the surface of the block, and do not turn the shutter valve any further.

   • Do not remove the shutter valves.

SUPPORT REAR AXLE HOUSING ASSEMBLY

1. 

   Support the rear axle housing with a jack using a wooden block to avoid damage.