REAR LOWER ARM INSTALLATION

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. TEMPORARILY INSTALL LOWER CONTROL ARM ASSEMBLY LH


    1. A015AM2

      Temporarily install the lower control arm and 2 washers with the 2 bolts and 2 nuts.

  2. STABILIZE SUSPENSION


    1. Install the rear wheels.

      Torque:
      for aluminum wheel
      131 N*m  { 1336 kgf*cm, 97 ft.*lbf }
      for steel wheel
      209 N*m  { 2131 kgf*cm, 154 ft.*lbf }

    2. Lower the vehicle.

    3. Press down on the vehicle several times to stabilize the suspension.

  3. TIGHTEN LOWER CONTROL ARM ASSEMBLY LH


    1. Tighten the 2 nuts.

      Torque:
      150 N*m  { 1530 kgf*cm, 111 ft.*lbf }

      Note

      Perform this procedure with all 4 wheels on the ground.

  4. MEASURE VEHICLE HEIGHT (w/ KDSS)

    Note


    • Perform the inspection on a level surface.

    • Ensure that the wheels are on the ground and facing straight ahead.

    • Perform the inspection with the vehicle load completely on the suspension.

    Tech Tips


    • Perform this step with the fuel tank full.

    • If there are any parts installed to the vehicle which place any unbalanced load on the left or right side of the vehicle, remove them.


    1. Set the tire pressure to the specified value(s) Click here.

    2. Bounce the vehicle to stabilize the suspension.

    3. A015AG2

      Measure the distance from the ground to the top of the bumper and calculate the difference in the vehicle height between left and right. Perform this procedure for both the front and rear wheels.

      Height difference of left and right sides
      15 mm (0.591 in.) or less

      Tech Tips

      If not as specified, perform the vehicle tilt calibration.

  5. CLOSE STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

    Note


    • Perform the inspection on a level surface.

    • Ensure that the wheels are on the ground and facing straight ahead.

    • Perform the inspection with the vehicle load completely on the suspension.

    Tech Tips


    • Perform this step with the fuel tank full.

    • If there are any parts installed to the vehicle which place any unbalanced load on the left or right side of the vehicle, remove them.


    1. Using a 5 mm hexagon socket wrench, tighten the lower and upper chamber shutter valves of the stabilizer control with accumulator housing.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

  6. INSTALL STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

    A0158P4

    1. Install the valve protector with the 3 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

    2. Attach the clamp, and connect the connector to the valve protector.