HEIGHT CONTROL SENSOR (for Rear Side) INSTALLATION

INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
1. Install the sensor with the 2 bolts and nut.
  
  Torque:
  
  for bolt
  
  13 N*m { 127 kgf*cm, 9 ft.*lbf }
  
  for nut
  
  5.6 N*m { 57 kgf*cm, 50 in.*lbf }
2. Connect the connector and 2 clamps.
INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
1. Install the sensor with the 2 bolts and nut.
  
  Torque:
  
  for bolt
  
  13 N*m { 127 kgf*cm, 9 ft.*lbf }
  
  for nut
  
  5.6 N*m { 57 kgf*cm, 50 in.*lbf }
2. Connect the connector and 2 clamps.
INSTALL REAR WHEEL

Torque:

for Aluminum Wheel

131 N*m { 1336 kgf*cm, 97 ft.*lbf }

for Steel Wheel

209 N*m { 2131 kgf*cm, 154 ft.*lbf }
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
PERFORM VEHICLE HEIGHT OFFSET CALIBRATION
1. Perform the vehicle height offset calibration Click here.
ADJUST REAR HEIGHT SENSOR LINK SUB-ASSEMBLY
Note
- Make adjustments from the link that deviates the most from the specified vehicle height value.
- When the front and rear are at the same level, make adjustments from the front first.
- If adjustment cannot be completed through the vehicle height offset calibration, adjust the sensor link using the following procedure.
1. Loosen the nut and adjust the link installation position by moving the height control sensor link up or down in the long hole of the bracket.
  
  Tech Tips
  
  When the link is moved 1 mm (0.0394 in.), the vehicle height changes by approximately 2 mm (0.0787 in.).
2. Tighten the nut of the height control sensor link.
  
  Torque:
  
  5.6 N*m { 57 kgf*cm, 50 in.*lbf }
PERFORM ZERO POINT CALIBRATION OF G SENSOR
1. Perform the zero point calibration of G sensor Click here.
ADJUST HEADLIGHT ASSEMBLY
1. for Standard:
  
  Adjust the headlight Click here.
2. for HID Headlight:
  
  Adjust the headlight Click here.