Click here

HEIGHT CONTROL SENSOR (for Rear Side) INSPECTION

Click here
Click here Click here
  1. Click here

    INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

    Note:

    Do not drop the height control sensor. If it is dropped, replace it with a new one.


    1. Connect 3 dry batteries of 1.5 V in series.

    2. Connect the positive (+) end of the batteries to terminal 1 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 3 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR*1, SHRL*2) and terminal 3 (SHG).

      Tip:

      *1: for RH

      *2: for LH

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Table 1. for RH
      Tester Connection Condition Specified Condition
      2 (SHRR) - 3 (SHG) Max. HI Approx. 4.1 V
      Normal Approx. 2.25 V
      Min. LO Approx. 0.45 V
      Table 2. for LH
      Tester Connection Condition Specified Condition
      2 (SHRL) - 3 (SHG) Max. HI Approx. 4.1 V
      Normal Approx. 2.25 V
      Min. LO Approx. 0.45 V
      Note:

      Do not apply a voltage of higher than 6 V.

      If the result is not as specified, replace the rear height control sensor.