Click here

REAR DIFFERENTIAL LOCK POSITION SWITCH (w/ Differential Lock) INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL NO. 1 TRANSFER INDICATOR SWITCH


    1. A0159F0E01

      Using a SST, install a new gasket and the indicator switch.

      09922-10010
      without SST
      40 N*m 408 kgf*cm 30 ft.*lbf
      with SST
      28 N*m 283 kgf*cm 20 ft.*lbf
      Note:

      • Rotate SST in the direction shown in the illustration.

      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).

    2. Connect the connector.

  2. Click here

    INSTALL REAR DIFFERENTIAL LOCK ACTUATOR PROTECTOR


    1. A015CIJ

      Install the protector with the 2 nuts.

      35 N*m 357 kgf*cm 26 ft.*lbf
  3. Click here

    INSTALL DIFFERENTIAL PROTECTOR ASSEMBLY


    1. A015DOE

      Attach the protector with the bolt and nut.

      15 N*m 150 kgf*cm 11 ft.*lbf

    2. Connect the 2 connector clamps and wire harness clamp.

      Note:

      Make sure the wire harness of the No. 4 transfer indicator switch fits inside the protector.