TRANSFER ASSEMBLY INSTALLATION


  1. INSTALL TRANSFER ASSEMBLY


    1. A015AJWE01

      Install the transfer with the 8 bolts.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note

      Take care not to damage the adaptor oil seal with the transfer input shaft spline.

  2. INSTALL MANUAL TRANSMISSION WITH TRANSFER ASSEMBLY (for H150F)

    Click here

  3. INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY (for AB60F)


    1. for 1VD-FTV:

      Click here

    2. for 1UR-FE:

      Click here

    3. for 3UR-FE:

      Click here

  4. INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY (for A750F)

    Click here

  5. ADD TRANSFER OIL


    1. A015AJZ

      Install a new gasket onto the drain plug and then install the plug.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
    2. A0159ZOE08

      Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.

      Note


      • Add oil slowly.

      • Add oil a little at a time, waiting several minutes between each addition of oil.

    3. Wait approximately 5 minutes and check that the oil level has not changed.

    4. A015BBP

      Install a new gasket onto the filler plug and then install the plug.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
    5. A015DHZ

      Install the lower transfer case protector with the 7 bolts.

      Torque:
      14 N*m  { 139 kgf*cm, 10 ft.*lbf }
    6. A01593H

      Install the transfer heat insulator with the 4 bolts.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }
    7. A0156Y8

      except 1GR-FE:

      Install the transfer dynamic damper with the 2 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  6. CHECK FOR TRANSFER OIL LEAK