TRANSFER OIL REPLACEMENT


  1. DRAIN TRANSFER OIL


    1. A0156Y8

      except 1GR-FE:

      Remove the 2 bolts and transfer dynamic damper.

    2. A01593H

      Remove the 4 bolts and transfer heat insulator.

    3. A015DHZ

      Remove the 7 bolts and lower transfer case protector.

    4. A015BBP

      Remove the filler plug and gasket.

    5. A015AJZ

      Remove the drain plug and gasket, and drain the transfer oil.

  2. ADD TRANSFER OIL


    1. A015AJZ

      Install a new gasket onto the drain plug and then install the plug.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
    2. A0159ZOE08

      Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.

      Note


      • Add oil slowly.

      • Add oil a little at a time, waiting several minutes between each addition of oil.

    3. Wait approximately 5 minutes and check that the oil level has not changed.

    4. A015BBP

      Install a new gasket onto the filler plug and then install the plug.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
    5. A015DHZ

      Install the lower transfer case protector with the 7 bolts.

      Torque:
      14 N*m  { 139 kgf*cm, 10 ft.*lbf }
    6. A01593H

      Install the transfer heat insulator with the 4 bolts.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }
    7. A0156Y8

      except 1GR-FE:

      Install the transfer dynamic damper with the 2 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }