TRANSFER OIL ON-VEHICLE INSPECTION

CHECK TRANSFER OIL
1. Remove the filler plug and gasket.
2. Check that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.
  
  If the result is not as specified, add transfer oil.
  
  Viscosity
  
  SAE 75W
  
  Standard Capacity
  
  1.4 to 1.5 liters (1.5 to 1.6 US qts, 1.2 to 1.3 Imp. qts)
  
  Note
  
  Too much or too little oil will lead to transfer problems.
3. When the oil level is too low, check for oil leaks.
4. Install a new gasket onto the filler plug and then tighten the plug.
  
  Torque:
  
  37 N*m { 377 kgf*cm, 27 ft.*lbf }
ADD TRANSFER OIL
1. Remove the filler plug and gasket.
2. Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.
  Note
  - Add oil slowly.
  - Add oil a little at a time, waiting several minutes between each addition of oil.
3. Wait approximately 5 minutes and check that the oil level has not changed.
4. Install a new gasket onto the filler plug and then tighten the plug.
  
  Torque:
  
  37 N*m { 377 kgf*cm, 27 ft.*lbf }